About Store Forum Documentation Contact



Post Reply 
Clicking on Parts in Mesh Editor -> Material Editor update
Author Message
Fluxor Offline
Member

Post: #1
Clicking on Parts in Mesh Editor -> Material Editor update
Now I see that the material editor always shows the red focused/selected material
from the "Outliner".

However, it would speed up editing quite a bit if there was some possibility
to update the material in the Material Editor when clicking on parts in the Mesh Editor
to the material that is assigned to that specific part.

Maybe only when "edit selected" is checked? Or maybe just another button inside the "Parts" Subwindow to "locate material" of the selected part or something like that?
Maybe just an entry in the right-click window? Something at least to
find a material of a selected mesh-part more quickly.

Let me know what you think.
(This post was last modified: 09-04-2021 07:33 PM by Fluxor.)
09-04-2021 07:31 PM
Find all posts by this user Quote this message in a reply
Esenthel Offline
Administrator

Post: #2
RE: Clicking on Parts in Mesh Editor -> Material Editor update
You can switch to LOD mode F3 key before clicking.
Or if have just one lod then you can also press F4 to disable MESH tab
And F5 Variations tab works.
09-05-2021 01:00 AM
Find all posts by this user Quote this message in a reply
Fluxor Offline
Member

Post: #3
RE: Clicking on Parts in Mesh Editor -> Material Editor update
Ahh, that's perfect!

Thanks.
09-05-2021 04:32 PM
Find all posts by this user Quote this message in a reply
Post Reply