About Store Forum Documentation Contact



Post Reply 
Problem with compatibility
Author Message
rafalfocus Offline
Member

Post: #1
Problem with compatibility
Wrong thread...I moved to support
Helo I have a problem whit compatibility my CInema 4d and Mesh Editor look below on screenshot
This is my model which i made in cinema:
[Image: test_6.jpg]

Evrithing is fine but my problem have begin when i export model to format file .obj and open this in mesh editor look below

[Image: test1.jpg]

Do you see this hole...mesh editor not take n-gons ? or something ? :( it is few problems. I have too problem which Textures, always when a make texture in cinema to file jpeg so it's alway wrong look below

[Image: test2.jpg]

I use projection in cinema uvw mapping but I can change this to cubic or other projection but always something is wrong ;( textures not spread good in model at mesh editor...

Can you doing somting ? it's very important for me..Thanks a lot for replay also can you writing to this message in polish laguage becouse me english in reading is not so good... Thanks agine.
Rafal
(This post was last modified: 02-21-2010 01:24 PM by rafalfocus.)
02-21-2010 12:04 AM
Find all posts by this user Quote this message in a reply
Esenthel Offline
Administrator

Post: #2
RE: Problem with compatibility
Hello,

I can take a look at your problem, please send me the source files (c4d, textures, and imported mesh gfx files)
02-22-2010 12:05 PM
Find all posts by this user Quote this message in a reply
rafalfocus Offline
Member

Post: #3
RE: Problem with compatibility
Thanks for replay I will send to you email now smile
02-22-2010 06:05 PM
Find all posts by this user Quote this message in a reply
Post Reply