About Store Forum Documentation Contact



Post Reply 
Can't load pak "../Data/engine.pak"
Author Message
Robert Fitzy Offline
Member

Post: #1
Can't load pak "../Data/engine.pak"
Every time I try and use the converter I get the error:

Can't load pak "../Data/engine.pak"

Im not sure if im using it wrong or something. From what I understand you drag and drop your mesh/texture on to the converter.exe. Is this right?
07-21-2009 06:01 PM
Find all posts by this user Quote this message in a reply
Esenthel Offline
Administrator

Post: #2
Re: Can't load pak "../Data/engine.pak"
Hi

Robert Fitzy Wrote:Every time I try and use the converter I get the error:

Can't load pak "../Data/engine.pak"
maybe you have copied the Converter.exe to another location?
the tool uses the "engine.pak" which is loaded at program start.
please launch it from the "tools" folder
1. extract the full SDK to your hard drive (make sure you have enough room)
2. don't copy any files, but just go to "tools" and run the "converter.exe"

if youll have any more problems let me know

Quote:Im not sure if im using it wrong or something. From what I understand you drag and drop your mesh/texture on to the converter.exe. Is this right?
no, please first run the converter.exe
and then drag and drop the files onto the tool's window (window, not the .exe file itself)
07-21-2009 06:12 PM
Find all posts by this user Quote this message in a reply
Robert Fitzy Offline
Member

Post: #3
Re: Can't load pak "../Data/engine.pak"
Esenthel Wrote:Hi

Robert Fitzy Wrote:Every time I try and use the converter I get the error:

Can't load pak "../Data/engine.pak"
maybe you have copied the Converter.exe to another location?
the tool uses the "engine.pak" which is loaded at program start.
please launch it from the "tools" folder
1. extract the full SDK to your hard drive (make sure you have enough room)
2. don't copy any files, but just go to "tools" and run the "converter.exe"

if youll have any more problems let me know

Quote:Im not sure if im using it wrong or something. From what I understand you drag and drop your mesh/texture on to the converter.exe. Is this right?
no, please first run the converter.exe
and then drag and drop the files onto the tool's window (window, not the .exe file itself)

lol, yeah I figured it out after. Thanks though. grin
07-21-2009 06:47 PM
Find all posts by this user Quote this message in a reply
Post Reply