About Store Forum Documentation Contact



Post Reply 
Minor Bug in Editor - Invalid Closing Brace
Author Message
Ozmodian Offline
Member

Post: #1
Minor Bug in Editor - Invalid Closing Brace
I think I found a minor bug in the code editor.

Steps
1) Open tutorial 13 - Mesh -> heightmap
2) Change the following line

Code:
Vec2 pos; SinCos(pos.y, pos.x, Time.time()); pos=pos*8+16;

to

Code:
Vec2 pos; SinCos(pos.y, pos.x, Time.time()); pos=pos*8;

3) Press play
4) Press escape to exit
5) Type back in the +16
6) Press play

Error displayed "Error: Invalid Closing Brace".

If you press control-Z twice to get the +16 back and press play it is good again. It is not consistent either. I get the error most of the time but sometimes not.

Please let me know if I can provide any further information. This is NOT urgent.

Thanks for the support.
04-05-2013 07:46 AM
Find all posts by this user Quote this message in a reply
Esenthel Offline
Administrator

Post: #2
RE: Minor Bug in Editor - Invalid Closing Brace
Thanks!

I had this problem appear too occasionally, but it always occured randomly and I never could reproduce it in debug mode, thanks to your catch maybe I'll be able to do something about it smile

temporary fix is to do on the code with the issue:
Ctrl+A - select all
Ctrl+X - cut
Ctrl+V - paste

it will rebuild the code and make it work as normal
04-05-2013 12:27 PM
Find all posts by this user Quote this message in a reply
Esenthel Offline
Administrator

Post: #3
RE: Minor Bug in Editor - Invalid Closing Brace
Okay, it wasn't easy but I've managed to solve the problem smile
However if it will happen again for some othe reasons, then please let me know.
04-05-2013 05:43 PM
Find all posts by this user Quote this message in a reply
Ozmodian Offline
Member

Post: #4
RE: Minor Bug in Editor - Invalid Closing Brace
Thanks Esenthel! I did not mean for you to spend a lot of time on it. Glad my steps helped you re-produce it. As always, going above and beyond! smile

Have a great weekend.
04-05-2013 07:06 PM
Find all posts by this user Quote this message in a reply
Post Reply