About Store Forum Documentation Contact



Post Reply 
Editor Water rendering disable option
Author Message
AndrewBGS Offline
Member

Post: #1
Editor Water rendering disable option
Hi, I would really appreciate a way to disable water from rendering in the editor;
I need this to properly model the terrain under water, which is currently very hard to do as I can't see it after the water is already there. And planning ahead doesn't always work.

I think a check-box that does this shouldn't be too hard to implement, and could be quite useful.
12-23-2014 09:20 PM
Find all posts by this user Quote this message in a reply
Ezequel Offline
Member

Post: #2
RE: Editor Water rendering disable option
Hi, maybe an idea for a temporary workaround: if you create a new water material with the density parameters all set to 0, you can then temporary replace the water material with that one and see trough the surface.
12-23-2014 11:05 PM
Find all posts by this user Quote this message in a reply
AndrewBGS Offline
Member

Post: #3
RE: Editor Water rendering disable option
Yes, that is the workaround i'm currently trying. Slightly annoying though.
12-23-2014 11:30 PM
Find all posts by this user Quote this message in a reply
Houge Offline
Member

Post: #4
RE: Editor Water rendering disable option
+1 for this!

If speaking about the water, one more thing will be very helpful in the editor, manual setting of Y water position via editbox. As i can see now it can be adjusted only via mouse drag.
12-24-2014 07:09 AM
Visit this user's website Find all posts by this user Quote this message in a reply
Post Reply