Hi,

I have a font of roughly 20mb that I'd like to use for chinese / jap / korean languages.

It works fine in the editor, but when i try to build, it has error 1023
and another one where it creates 80m images ?

i have reduced it slowly, and it seems that 1 font using this type is fine, but anymore than 1 and it causes the issue seen in the screenshot.

i can share the font if needed

Reduce your font "Size", with these settings your font size can reach 2GB+.

oh i see how this works now, thanks that did the trick !

do you typically have asian and other font separated ?
200mb per font still seems a bit excessive, but else the resolution is too low on latin alphabet

Yes I separate. The font with asian will have lower size, and font without, will have bigger size.

ok i see, unfortunately i dont think this could be working for my project, since i can have a mix of chinese and latin alphabet together.

would be it complex to change size to have 2 separate entries, one for ASCII character, one for the other character, not sure how that would work ?