About Store Forum Documentation Contact


Esenthel Forum / Esenthel Engine / Support / Tools v / Mesh Editor... Smooth problerm

Post Reply 
Mesh Editor... Smooth problerm
Author Message
zelft Offline
Member
Post: #1
Mesh Editor... Smooth problerm
Hi
I have a problem with MESH EDITOR, How to make a model that was "smooth" because it can be seen on the cut. How does it smooth out?
screen, so you can see:
[Image: problemwj.jpg]
How smooth the model?

Ps. Textur model is merged

Yours
(This post was last modified: 08-20-2011 02:44 AM by zelft.)
08-20-2011 01:34 AM
Find all posts by this user Quote this message in a reply
Zervox Offline
Member
Post: #2
RE: Mesh Editor... Smooth problerm
try weld -> normals
08-20-2011 03:10 AM
Find all posts by this user Quote this message in a reply
Esenthel Offline
Administrator
Post: #3
RE: Mesh Editor... Smooth problerm
1. menu\mesh\set duplicates
then
2. menu\mesh\set normals
08-24-2011 02:04 PM
Find all posts by this user Quote this message in a reply
Post Reply