Can you please add the ability to use the scale dialog box to change the skeleton the same way as you can scale a mesh.

This would allow for the use of exact values when scaling skeletons down to match meshes.

Alternatively could there be a tick box in mesh scale dialog to also scale the skeleton the same as the mesh?

Yeah well if you're just doing scaling down to meshes you can remove the mesh, scale the skeleton, then re-add the mesh. But having the scaling options normally available during mesh editing would be useful and has been suggested before.

+1

It would also be nice to be able to transform->center a skeleton as well.

load mesh+skel
rescale both in mesh mode
save mesh+skel

Does this also work for centering?

yes, it should

Thanks seems after performing the scale/center I was not re-saving the skeleton.